The proper way to mount a scope is by positioning the rifle as you would when about to take a shot. To avoid muscle aches, position yourself in a comfortable angle, giving emphasis to your head and neck. Your posture should always be taken into consideration when mounting your scope.

You must make sure that all necessary equipments are on hand before following these rifle scope mounting instructions. The scope, unloaded rifle, scope mount or bade, mounting rings and a set of tools including screwdrivers and allen wrench must be prepared. The mounting of the scope is best done on a well-lighted and clutter free area. For those rifles that are not yet ready for scope mounts, bring them to a gunsmith and they’ll know what to do.

Choose the position you’re most comfortable in. If you prefer to kneel, then get in that position before mounting your scope. There are different adjustments suited for different positions.

Scope bases also vary. Among them are Weaver, Picatinny, Redfield/Leupold and clam-on mounts. Several rifle manufacturers place the scope base directly into the receiver. This is where the firing mechanism and ammunition feed system are located. Using clamps or screws, attach the scope base to the rifle. The mounting rings must be matched to the scope and base or else complications will arise later on.

The mounting rings are composed of two-piece clamps. The lower part of the rings must be directly connected to the scope base. The upper half of the ring locks the scope in place while it stands in the lower half. Mounting rings come in various sizes which depend on the size of your scope’s objective lens.

Securing your rifle in a gun vise is a must before starting. Your rifle’s receiver and the base and rings bottom should be applied with a thin layer of oil. You must do this in accordance to the instruction given and the type of base you have chosen. Each hole needs a different screw so make sure to use the right kind for each. Connect the base to the receiver followed by the bottom half of the mounting rings to the base. Check again to make sure that there are no loose connections.

Go out and locate an area where a target can be set up. You’ll need to be at least 25 yards (22.9m) away. Take off the bolt on your rifle. Put a bore sighter in the rifle’s muzzle and take a look at the bore of the rifle. Set your scope to its highest magnification and put it on the bottom half of the mounting rings. Place the top rings over your Kahles rifle scopes. Make sure that they are loosely secured. In this way, the scope’s position can still be adjusted. It is advisable to position the scope’s reticle inside the bore sighter’s reticle without having to jerk the scopes adjustment settings. If you can’t do this then try to alter the position of the mounting rings with the use of the scope’s screws and knobs. Its quality has to be close to perfect as possible. Hopefully you found these rifle scope mounting instructions helpful. Best of luck!